Strøm

Hall-Effect Current Sensor Breakout - ACS712

BOB-08882

Ny vare

The ACS712 outputs an analog voltage output signal that varies linearly with sensed current. The device requires 5VDC for VCC and a couple of filter capacitors. Please keep in mind that though the ACS712 is rated for 2.1kV isolation, the PCB it is on is not designed for that type of voltage. Please keep that in mind if you are using this breakout in high voltage applications.

Flere detaljer

88 Styk på fjernlager bestil før Torsdag kl 15 og modtag denne varer Tirsdag ugen efter

Få en mail når varen er på lager
Du får en mail så snart varen er på lager

79,50 kr

Yderligere information

This is a breakout board for the fully integrated Hall Effect based linear ACS712 current sensor. The sensor gives precise current measurement for both AC and DC signals. Thick copper conductor and signal traces allows for survival of the device up to 5 times overcurrent conditions.

Features:

  • x05B (5 Amp) version
  • Low noise analog signal path
  • Device bandwidth is set via the FILTER pin
  • 5us output rise time in response to input current
  • 80kHz bandwidth
  • 1.5% output error at 25 degrees C
  • 1.2mOhm internal conductor resistance
  • 5.0 VDC, single supply operation
  • 185 mV/A output sensitivity
  • Output voltage proportional to AC or DC currents
  • Factory-trimmed for accuracy
  • Extremely stable output offset voltage
  • Nearly zero magnetic hysteresis
  • Ratiometric output from supply voltage

Documents:

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter