Kraft / Flex

Force Sensitive Resistor 0.5"

SEN-09375

Ny vare

Two pins extend from the bottom of the sensor with 0.1" pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.

Flere detaljer

Udsolgt ved leverandør, se leverandørens leveringstid https://www.sparkfun.com/products/9375

69,50 kr

Yderligere information

This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.

These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.

Note: As it states in the Integration Guide, do NOT solder directly to the exposed silver traces. With flexible substrates, the solder joint will not hold and the substrate can easily melt and distort during the soldering. We recommend using a male or female clincher connector instead.

Features:

  • Overall length: 2.375"
  • Overall width: 0.75"
  • Sensing diameter: 0.5"

Documents:

Videos

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter