Batteri

Battery Holder - 4xAA to Barrel Jack Connector

PRT-09835

Ny vare

This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector.

Flere detaljer

135 Styk på på fjernlager, bestil før Fredag kl 14 og modtag denne varer Onsdag ugen efter

31,70 kr

Yderligere information

The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easily make your project battery powered.

Note: the average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends a lot of what board and processor you are using with the battery pack. Please consult yer datasheet.

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter