Motor

Servo Extension Cable - Female to Female (shrouded)

ROB-08738

Ny vare

This is a 12" servo extension cable. This comes in very handy when your servo is further away from the controller than the wire on the servo allows. Male connector on one end goes to controller, female connector mates with servo. Fits all Hitec, Futaba, JR, Multiplex, and Airtronics Z servos. Wire can also be used as a simple 0.1" jumper cable.

Flere detaljer

261 Styk på fjernlager bestil før Torsdag kl 15 og modtag denne varer Tirsdag ugen efter

Få en mail når varen er på lager
Du får en mail så snart varen er på lager

31,70 kr

Yderligere information

Note: These wires have a weird naming convention. Both ends of this wire have what, in most cases, should be called a female connector; but, for these wires, the presence (or lack thereof) of the plastic shroud is what makes an end female or male. If you’re looking to plug one end of these wires into a breadboard, you could stick our breakaway male headers into the un-shrouded end to make it a true male connector.

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter