Komponenter

PowerSwitch Tail II

COM-10747

Ny vare

The PowerSwitch Tail II is designed to allow you to safely control an outlet device without exposing any 120VAC voltages. You can plug in any standard 120VAC 3-prong outlet to be controlled by most any microcontroller. This will work great with Arduino! The PowerSwitch Tail II improves on the original PowerSwitch Tail by allowing you to switch a bigger load (now up to 15A) with a wider range of control signals (3-12VDC). The PowerSwitch Tail II can be setup for normally open or normally closed operation by changing a jumper inside the unit with the default set as open.

Flere detaljer

112 Styk på fjernlager bestil før Torsdag kl 15 og modtag denne varer Tirsdag ugen efter

Få en mail når varen er på lager
Du får en mail så snart varen er på lager

311,80 kr

Yderligere information

Want to control a standard wall outlet device with your micro controller, but don’t want to mess with the high voltage wiring? This might just be the right device for you!

Features:

  • Connect to Arduino, PIC, Stamp, or other MCU with driver transistor or ULN2803
  • LED indicator shows status of control signal
  • Connect output receptacle to a single powered device or to a power strip to control multiple loads.
  • Switches up to 15A (resistive loads) with a 3-12VDC, 3-30mA control signal.

Documents:

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter