Et godt begynder kit
LED mix med forskellige farver
This smart SMD tester is essentially a pair of multimeter tweezers. This allows you to troubleshoot circuits with small SMD parts without having to fumble with large probes or long wires. Test resistors, capacitors and diodes one-handed!
Next time you need to check the current on your robot’s motors, connect the Mooshimeter and drive the bot around while viewing (or logging) your current draw. Not only that but with the multi-channel feature you can also measure voltage (and consequently total power) at the same time. You are no longer tethered to your multimeter.
The SparkFun Inventor’s Kit (SIK) is a great way to get started with programming and hardware interaction with the Arduino programming language. The SIK includes everything you need to complete 16 circuits that will teach you how to read sensors, display information on an LCD, drive motors, and more.
The Watt’s Up is perfect for situations when you need to prevent peak currents damaging a battery, operating motors balancing battery cells, setting cutoff voltages and more. Each Watt’s Up has been equipped with two sets of wires marked “SOURCE” and “LOAD” as well as a 16x2 black-on-green sharp LCD screen.
This non-contact infrared thermometer makes it a breeze to take quick and accurate surface temperature readings without getting too close for comfort. Laser sighting ensures that you’re pointing at the right spot: Simply pull the trigger and line up the laser dot where you want to measure the temperature.
Turns out the ATMega328 is pretty far over-spec for just controlling a parallel LCD so there’s a lot of horsepower left over to do whatever else needs to be done. We’ve broken out all of the unused GPIO pins to 0.1" headers on one side of the board, making this more than just a great kit for beginner soldering but also an awesome development...
These needle tipped multimeter probes are great for attaching to multimeters, power supplies, oscilloscopes, function generators, etc.
The online STK Experiment Guide (in the Documents section below) contains step-by-step instructions of how to connect each circuit with the included parts. Full example code is provided and explained, and even includes troubleshooting tips in case something goes wrong.
This isn’t your expensive, flashy type of multimeter, this is for all those starving students that need to buy their first good, low-cost digital multimeter. This meter doesn’t have the ability to auto-power off, it isn’t capable of auto-ranging, and it won’t be able to measure frequency.
Et godt starter kit til nybegynderen. Med masser af muligheder for at lære Arduino .....på en sjov måde.
Et godt starterkit til nybegynderen. Dette er et mindre sæt, til dig der gerne vil se .......om Arduino er noget for dig.
Logic supply voltage (VCC) can be in the range of 2.7–5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
Kun ved let-elektronik.dkLet-elektronik er stolte af at være først i Danmark med et Arduino starterkit med dansk bog. I bogen er der i alt 50 Arduino kredsløb og programmerings eksempler med tilslutningsdiagrammer og programeksempler. Der er beskrivelser af programmernes opbygning og koder. Alt underbygget af illustrationer og billeder i farver.
Et godt kit til dig der ikke vil mangle noget. Her åbner der sig en masse muligheder .......til mange timers voksentid.
Original Arduino starterkit