7-Segment

MiniGen - Pro Mini Signal Generator Shield

BOB-11420

Ny vare

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.

Flere detaljer

61 Styk på på fjernlager, bestil før Fredag kl 14 og modtag denne varer Onsdag ugen efter

299,50 kr

Yderligere information

3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

This is the SparkFun MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter