Shields

Arduino Ethernet Shield 2

DEV-11166

Ny vare

There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Uno and Mega (using the Ethernet library). The onboard micro-SD card reader is accessible through the SD Library. When working with this library, SS is on Pin 4. The original revision of the Shield contained a full-size SD card slot; this is not supported.

Flere detaljer

294 Styk på fjernlager bestil før Torsdag kl 15 og modtag denne varer Tirsdag ugen efter

Få en mail når varen er på lager
Du får en mail så snart varen er på lager

491,00 kr

Yderligere information

The Arduino Ethernet Shield 2 allows an Arduino Board to connect to the Internet. It is based on the Wiznet W5500 Ethernet chip. The Wiznet W5500 provides a network (IP) stack capable of both TCP and UDP. It supports up to eight simultaneous socket connections. Use the Ethernet library to write sketches that connect to the Internet using the Shield. The Ethernet Shield 2 connects to an Arduino Board using long wire-wrap headers extending through the Shield. This keeps the pin layout intact and allows another Shield to be stacked on top of it.

The shield also includes a reset controller, to ensure that the W5500 Ethernet module is properly reset on power-up. Previous revisions of the Shield were not compatible with the Mega and needed to be manually reset after power-up. The most recent revision of the board exposes the 1.0 pinout on rev 3 of the Arduino UNO Board. The Ethernet Shield 2 has a standard RJ-45 connection, with an integrated line transformer and Power over Ethernet enabled but please be aware that this shield does not come with a built in PoE module. The PoE module that will need to be added on is a separate component that must be added on. This shield also features several TinkerKit input/output and communication interfaces that can be found on the topside of the board.

Features:

  • Operating voltage 5V (supplied from the Arduino Board)
  • Ethernet Controller: W5500 with internal 32K buffer
  • 2x TinkerKit Inputs, Outputs, and TWI Pins Each
  • Connection speed: 10/100Mb
  • Connection with Arduino on SPI port

Documents:

Varetilpasning

Når du har gemt din kundetilpassede vare, skal du huske at tilføje den til din kurv.

loader

* obligatoriske felter